Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1.
Dim Atmos Lighting
2.
Increase flame height /shuffle flame
height
3.
Lower volume of Kalfire Sound
4.
Adjust flame intensity
5.
Atmos Heating on/off
6.
Lower ember bed intensity
7.
Dynamic ember bed on/off
8.
Power on/off / Anti-reflect function
9.
Brighten Atmos Lighting
10.
Dynamic Atmos Lighting on/off
11.
Raise volume of Kalfire Sound
12.
Decrease flame height
13.
Adjust flame type
14.
Adjust sound type
15.
Higher ember bed intensity
5.2
Bluetooth pairing E-one remote
When the fireplace is used for the first time,
the remote control will connect to it
automatically. If the following symbol is
projected on the rear screen of the fireplace,
the remote control must be paired manually.
Manual pairing is done by pressing the
and
buttons on the remote control at
same time.
Release the buttons when a red LED light
flashes in the top-left corner of the remote
control. You will know when the remote
control is successfully paired with the E-one
when the Bluetooth symbol is no longer visible.
5.3
Control
Switching the fireplace on
Briefly press the on/off button. It takes about
30 seconds for the fireplace to fully start up.
You can ignore any messages displayed on the
screen.
Adjust flame type
You can choose one of three different flame
types: dynamic wood fire (A), gas fire with a
bright, light flame colour (B), or gas fire with a
warm, darker flame colour (C).
Adjustable Flame Height
Provided that it is indicated on the display in
the fireplace, the flame height is adjustable
from position 1 to 5.
Position 6 is the flame shuffle mode, which
creates a dynamic play of flames. of varying
heights.
Adjust flame intensity
This function allows the brightness of the
flames to be adjusted according to the
ambient light in the room.
Ember bed intensity
Hybrid LED E lighting under the fire simulates a
realistic glowing bed of embers. The intensity is
adjustable from levels 1 to 5.
Switch on the dynamic ember bed button (7)
to make the glowing ember bed flicker. In this
mode, the intensity is adjustable from levels 1
to 5 using the ember bed intensity buttons (6)
(15).
Adjust Atmos Lighting
Atmos Lighting projects shadow effects on the
ceramic logs, enhancing the ultra-realistic fire
experience. The intensity is adjustable from
levels 1 to 5.
The Dynamic Atmos Lighting button provides a
varied flickering effect. In this mode, the
intensity is also adjustable from levels 1 to 5
using the Atmos Lighting + and - buttons.
Adjust Kalfire Sound
31
Werbung
