Beurer HD 75 Gebrauchsanleitung Seite 12

3. Intended use
CAUTION
This heated overblanket is only designed to warm up the human body.
4. Operation
4.1 Safety
CAUTION
The heated overblanket is fitted with the SAFETY SYSTEM. This electronic sensor technology provides
protection against overheating across the entire surface of the heated overblanket with an automatic
switch-off if there is a fault.
Please note that, for safety reasons, the heated overblanket can no longer be operated after a fault
has occurred and must be sent to the specified service address.
4.2 Initial use
• First, connect the controller to the heated overblanket by inserting the plug-in
coupling.
• Then plug the mains plug into the socket.
4.3 Switching on
To switch the heated overblanket on, set the sliding switch for ON/OFF and temperature settings to setting
1, 2, 3, 4, 5 or 6.
When it is switched on, the indicator lamp (4) lights up.
4.4 Setting the temperature
Level 0: OFF
Level 1: minimum heat
Setting 2 - 5: individual heat setting
Level 6: maximum heat
WARNING
If the heated overblanket is being used over several hours, we recom-
mend that you set the lowest temperature setting on the controller to
avoid overheating the person using the blanket.
NOTE
The fastest way to warm up the heated overblanket is to initially set the highest temperature setting.
4.5 Switching off
To switch off the heated overblanket, slide the sliding switch for ON/OFF and temperature settings to the
OFF ( 0 ) position.
NOTE
If the heated overblanket is not being used for several days, slide the sliding switch for ON/OFF and
temperature settings to the OFF ( 0 ) position and remove the mains plug from the socket.
Then disconnect the controller from the heated overblanket by unplugging the plug-in coupling.
12