Hama SIRIUM2000AMBT Kurzanleitung Seite 13

• Open the Amazon Alexa App and if necessary re-enter
your access details. You should then nd the loudspeaker
in your active devices.
• Then adjust your personalised settings (time zone,
device name, etc.) in the Amazon Alexa app. Further
information on this can be found at www.amazon.com
-> Help and Customer Service.
Note
• If the Amazon Market App has already been installed
and set up on your smartphone, some smartphones
will take the user data directly from the App.
• To set up a new Amazon account, log out and repeat
the steps described in this section.
Note Alexa Push to talk/ Function Key
• Brie y press the [Action] button (4) on the loudspeaker
to activate Alexa during audio mode or higher volume.
Alternatively, press the [Action] button (3) on the
remote control.
• Press the [Microphone Mute] button (3) to switch the
microphone off. If the microphones are deactivated,
the status LEDs (1-5) light up solid red. Alternatively,
press the [Microphone Mute] button (4) on the remote
control.
• The loudspeaker will now no longer respond to the
activation word until the microphones are reactivated.
• Press the [Microphone Mute] button (3) again to
reactivate the microphone. Alternatively, press the
[Microphone Mute] button (4) on the remote control.
The status LEDs (1-5) go out.
6. Bluetooth pairing
You can pair your terminal device with the speaker via
Bluetooth and use the speaker as a playback device for
audio signals. Playback is controlled directly via the device
or the remote control. The volume can also be controlled
directly on the speaker.
Note – Bluetooth
®
• Check whether your mobile device (smartphone,
tablet, etc.) is Bluetooth
• Note that the maximum range for Bluetooth
10 metres without obstacles such as walls, people, etc.
• The Bluetooth connection may be disrupted by other
®
Bluetooth
devices/connections in the vicinity.
®
• It is only possible to connect the speaker to one
terminal device.
• Note that compatibility depends on the supported
Bluetooth pro les as well as the Bluetooth
®
being used. (See Technical speci cations, operating
instructions of the terminal device in use)
• Ensure that your Bluetooth-enabled device is switched
on and that Bluetooth is activated.
• Activate Bluetooth mode by repeatedly pressing the
[SOURCE] button (2) on the loudspeaker.
• Alternatively, press [Bluetooth] (13) on the remote
control.
• The Bluetooth status LED (4) starts to pulse blue.
• Press and hold the [SOURCE] button (2) for around
2 seconds to activate pairing mode. The Bluetooth status
LED (4) starts to ash blue and a signal tone sounds.
• Open the Bluetooth settings on your terminal device and
wait until Hama SIRIUM2000AMBT/SIRIUM2100AMBT
appears in the list of Bluetooth devices found.
• If necessary, start searching for Bluetooth devices on
your terminal device.
• Select the Hama SIRIUM2000AMBT/SIRIUM2100AMBT
speaker in the list of available devices and wait until the
speaker is shown as connected in the Bluetooth settings
on your terminal device.
• The Bluetooth status LED (4) is now constantly lit blue.
• Start and control the audio playback accordingly via the
device or remote control.
Note – Bluetooth password
®
• Some terminal devices require a password in order to
connect to another Bluetooth
• If your terminal device requests a password for
connection to the speaker, enter 0000.
-capable.
®
is
®
versions
®
device.
®
5