Hama SIRIUM2000AMBT Kurzanleitung Seite 11

3. Safety Notes
• The product is intended for indoor use only.
• The product is intended for private, non-commercial use
only.
• Protect the product from dirt, moisture and overheating
and use it in dry rooms only.
• As with all electrical devices, this device should be kept
out of the reach of children.
• Do not drop the product and do not expose it to any
major shocks.
• Do not operate the product outside the power limits
given in the speci cations.
• Keep the packaging material out of the reach of children
due to the risk of suffocation.
• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the device in any way. Doing so voids the
warranty.
Risk of electric shock
• Do not open the device or continue to operate it if it
becomes damaged.
• Do not use the product if the AC adapter, adapter
cable or power cable is damaged.
• Do not attempt to service or repair the device yourself.
Leave any service work to quali ed experts.
Warning – Batteries:
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking or
exploding.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not being
used for an extended period
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Immediately remove and dispose of dead batteries
from the product.
4. Getting started
Preparing the remote control for use
Open the cover on the battery compartment. This can
be found on the back of the remote control and can be
opened by sliding in the direction indicated. The extent
of delivery includes two AAA batteries which must be
inserted into the battery compartment for the remote
control to work. When inserting the batteries, ensure that
they are inserted with the correct polarity. The relevant
polarity (+ / -) is marked inside the battery compartment.
Warning
• Connect the product only to a socket that has been
approved for the device. The socket must be installed
close to the product and must be easily accessible.
• Disconnect the product from the power supply using
the on/off switch – if this is not available, unplug the
power cord from the socket.
• When using a mult-socket power strip, make sure that
the sum power draw of all the connected devices does
not exceed its maximum throughput rating.
• If you will not be using the product for a long period
of time, disconnect it from mains power.
Turning on the product
• Connect the mains lead on the loudspeaker to a properly
installed socket.
• The loudspeaker switches on automatically.
Note – Turning on for the rst time
• When rst switched on, the loudspeaker is in "Device
setup" mode and the status LEDs (1-5) pulse.
• If setup mode is not active, brie y press the [SETUP]
button (2) on the back of the device to activate WPS
mode ( ashes rapidly). Alternatively, press and hold
the [SETUP] button (2) for around 7 seconds to open
an AccessPoint ( ashes slowly).
• At the next switch-on, all of the status LEDs (1-5) ash
orange until the connections made so far have been
restored. Depending on the Internet signal strength,
this may take up to 20 seconds.
Switching on / off / standby
• Press [POWER] (1) to switch on the loudspeaker.
Alternatively, press [POWER] (1) on the remote control.
• Press [POWER] (1) again on the device or the remote
control to switch the loudspeaker off. (Standby)
3