EuroLite IP AUDIENCE BLINDER 2x100W LED COB WW Bedienungsanleitung Seite 22

POWER SUPPLY
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts. The
power connectors are designed according to protection class IP65. Matching connection cables with special
plugs are optionally available. When not in use, make absolutely sure to close the connections with the
rubber sealing caps to prevent moisture and dirt from penetrating.
1 Connect the device via the mains cable to a grounded mains socket. Thus the unit is switched on.
2 To switch off the unit, disconnect the power plug.
3 Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains
outlet which is switchable.
4 The jack POWER OUT allows for power supply of further devices. To interconnect several devices,
connect the jack POWER OUT to the input POWER IN of the next unit until all units are connected. In
this manner, up to 8 devices can be linked at 230/240 input voltage and up to 4 devices at 110/115 input
voltage.
OPERATION
After you connected the effect to the mains, the device starts running and the display shows A001. The
operating modes can be selected by means of the display and the control buttons. All settings remain stored
even if the device is disconnected from the mains. The device can be operated in stand-alone mode via the
control board or in DMX-controlled mode via any commercial DMX controller.
Stand-alone mode
In stand-alone mode, the device can be used without controller. Disconnect the device from the controller.
Please refer to the instructions under Menu structure.
The main menu is accessed after you connected the effect to the mains. Browse through the menu by
pressing MENU. Press ENTER in order to select the desired menu. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every mode by pressing MENU.
The functions provided are described in the following sections.
22/28 00148544, Version 1.0