Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Descaling the limescale collector *
1 Place the limescale collector under the water tap.
2 Wash it up until limescale residues are removed.
Descaling the iron
1 Fill the tank (9) with tap water.
2 Plug in the mains cable (6) and press the button (1) to
switch the appliance on.
3 Press the descaling button (2) for 2 seconds. Its
indicator light will remain permanently lit.
4 Wait until the indicator light (1) stops lashing and
remains lit permanently. Two beeps will be heard.
5 Hold the iron in a horizontal position over an empty
sink to collect the water.
If your appliance is equipped with a "Calc'nClean"
container (17*), place the iron on it.
Warning: the container must only be used to
perform the descaling process. It must not be
used as a stand for the iron while ironing.
6 Press the steam release button (14) for 2 seconds. The
descaling process will start automatically. Warning:
boiling water and steam will be released through
the soleplate, carrying limescale and/or deposits
that may be inside. During the process, a beep will
be heard every 5 seconds.
7 After approximately 3 minutes, the iron will stop
releasing steam. A long beep will be heard, indicating
that descaling process has inished. The appliance will
switch off automatically.
8 To clean the soleplate (16), immediately rub off any
residue by running the hot iron over a wet cotton cloth.
* Model dependent
2x
5"
2"
B OS CH
2"
19
Werbung
