Philips MicroCube DI DACH Kurzanleitung

MicroCube DI DACH_EN
Connectivity
You can use the app to control the puri er and check air
quality. Download and install the Philips app
Clean Home+
Open the app and click on "Connect a New Device" or
press the "+" button to connect your device. Please follow
the steps in the app.
Control
Power Light Auto
dim mode
Hold for 3 seconds to
switch mode:
PM2.5 / IAI /GAS
Display
Sleep Speed 1 Speed 2
mode
Filter replace Pre- lter clean General
alert alert mode
Gas PM2.5 Allergen index
indicator indicator indicator
Allergen index from 1 to 12
where 1 indicates best air quality
Fan Child Filter
speed
lock reset
Hold for
Sleep
3 seconds
Speed 1~3
Turbo
Speed 3 Turbo
speed
Allergen Bacteria &
mode Virus mode
WiFi 3-digit display Air quality
indicator PM2.5 / IAI ring
Good Fair Poor Very poor
Maintenance
1
2 3 4
NanoProtect lter
Pre- lter x 2
2 3
Active Carbon x 2
When display shows F0
Time to clean the pre- lter
When display shows A3 When display shows C7
Time to replace NanoProtect lter Time to replace NanoProtect lter
Series 3 Active Carbon
!
press for 3 seconds to reset after cleaning or replacing accessory
The lter may produce smell after being used for a while because of the
absorption of indoor air. Remove the lter and place it where it has direct sunlight
and ventilation for several hours. Re-install and try using it again. If the odor
remains, please replace the lter.
90x127mm
1
NanoProtect lter
4
Series 3 x 2
1
2
4241 210 94514-1