Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
position '±' in order to remove screws.
Drilling
•
Rotate the torque adjustment ring (5) to the
drilling position.
Ensure that the direction reversing
switch (1) is always set to '' during
drilling.
Switching the device on and off
Fig. A
•
Depress the on/off switch (4). It regulates the
speed of the appliance by transmitting power
to the switch.
•
Release the on/off switch (4) to halt the drill
chuck immediately, it will no longer run on.
•
Move the direction reversing switch (1) to the
centre in order to lock the appliance in its
disabled state.
Only lay down the appliance when it has stopped
running completely. Do not place it on a dusty
surface as particles of dust could get into the
mechanism.
Spirit level
Fig. H
The drill is equipped with a dual reading horizontal/
vertical level to assist in keeping the drill "level"
while drilling horizontal and vertical holes. The
horizontal level (13) is located in the top of the drill
housing. The vertical level (14) is located on the
rear of the drill housing.
To maintain a level drilling position, hold the drill
where the level bubble is centred in the level
indicator circle.
Charging the battery
•
The included battery is delivered in partly
charged condition.
•
Only use the battery charger in a temperature
range between + 5 °C to + 40 ºC.
•
Only use the battery charger in dry, ventilated
rooms.
Charging
Fig. F
One advantage of using Lithium-Ion batteries is
that, until the battery is almost empty, hardly any
power fading is noticeable. The machine can be
used until you start noticing that the power of the
drill is elapsed. The battery is discharged now and
8
needs to be charged.
Charging the battery
Fig. F
•
Place the battery stem (9) into the matching
cavity on top of the charger (10).
•
Make sure the battery stem is pressed fully
into the charger as far as it will go.
•
Plug the charger into the electrical outlet.
LED indicators
Fig. G
When the battery charger is plugged in and the
battery inserted, the battery charger will begin
charging the battery. The red LED (11) and the
green LED (12) on top of the charger will indicate
the charging status.
•
When the charger is plugged in without a
battery inserted, the green LED (12) will be lit
up.
•
When a battery is inserted, the red LED (11)
will start blinking, indicating charging has
started.
•
When the battery is full, charging will stop and
the green LED (12) will start blinking.
•
If the battery is left in the charger, the charger
will go on standby after 2 hours. The green
LED (12) will stop blinking and light up.
When an error occurs the red LED (11)
will be lit up.
If the temperature of the battery is too
high to get charged safely, both the
green LED (12) and red LED (11) will be
lit, indicating charging process is on
hold. Charging will start when the
battery has cooled down.
Lithium-Ion cells can be stored for a
long period without losing much of their
charge. When the machine is not being
used over a longer period of time, it is
best to store the battery in charged
condition.
Ferm
Werbung
