Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
OPERATION
After you connected the effect to the mains, the LEDs of the LED Strobe light up briefly.
The device has two operating modes. By turning the Sound/Auto buttons, you can switch between operating
modes.
Blue Poti:
Flash frequency in auto mode and flash delay in sound mode (0 – 4 sec.).
Orange Poti:
Sound mode with adjustable microphone sensitivity. After every bass beat the device emits a sequence of
flashes.
CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
Should you have further questions, please contact your dealer.
TECHNICAL SPECIFICATIONS
Article:
Power supply:
Power consumption:
Flash-rate:
Maximum ambient temperature T
Maximum housing temperature T
Min. distance from flammable surfaces:
Min. distance to lighted object:
LED type:
Number of LEDs:
Color temperatur:
Sound-control:
Dimensions (LxWxH):
Weight:
Please note: Every information is subject to change without prior notice. 14.07.2016 ©
DANGER TO LIFE!
100-240 V AC, 50/60 Hz ~
13 W
10 Hz
:
45° C
a
(steady state): 70° C
C
0.5 m
0.1 m
SMD 5050, white
270
6400 K
via built-in microphone
53 x 240 x 150 mm
0.35 kg
13/13
52200864
00100883.DOC, Version 1.0
Werbung
