Marq Ray Tracer Quad Benutzerhandbuch Seite 4

Verfügbare Sprachen

Features

Rear Panel

1. Power In: Use a standard power cable (included) to connect this input to a power outlet.

2. Fuse: This compartment holds the fuse. Before cleaning or replacing the fuse, disconnect Ray

Tracer Quad from its power source. Use a screwdriver or other tool to remove the

compartment (do not pull it out by the tab only). Replace the fuse only with a new fuse with the

same rating (250 V, 5 A).

3. Power Out: Use a standard power cable to connect this output to an additional fixture. This

connection will supply power to the additional fixture when this one is connected a power outlet.

Please see

Setup > Linking > Power

Note: On models sold in the USA, this will be a standard "Edison" (NEMA

models, this will be a standard IEC connection.

4. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)

to another fixture that will pass DMX data through it to this one. Ray Tracer Quad receives DMX

data over this connection. Please see

multiple fixtures.

5. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture. Ray

Tracer Quad sends its data to an additional fixture over this connection. Please see

Linking > DMX

6. Display: This display shows messages and values indicating the fixture's current status.

7. /Prev: Press this button to select the next-highest menu option or to increase the value by 1.

8. /Next: Press this button to select the next-lowest menu option or to decrease the value by 1.

9. Enter: Press this to confirm your current selection or value.

2 3

for information about linking multiple fixtures.

Setup > Linking > DMX

8 9

) connection. On other

for information about linking

Setup >