Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1-4 Opening and closing the platform
Before installing the platform in the use position,
the leg's two locking pins need to be removed, in
the folded position.
Deploy the legs to bring them into their use
position, completely open.
For this operation, the user must hold the platform
in the horizontal position using the transport handle
and the slot on the platform used as a handle for
moving the platform in the use position.
1-5 Fitting the guard rails
Fit one of the two guard rails on the platform's
frame ensuring that the gate is folded inwards.
Fit the second guard rail on the platform's frame
ensuring also that the gate is folded inwards. Close
the gate opposite the access point by clipping it on
the guard rail tube.
Then simultaneously lock each of the legs on the
frame and the guard rail uprights using the 4 pins.
To close the platform, the user must carry out the
previously described operations in reverse order.
1-6 Adjusting the height of the platform
To adapt the platform to suit the height of the work
location, and for the user to carry out his job in good
conditions, he must individually adjust the 4 legs as
follows:
a) Grip one of the platform's legs, remove the
locking pin, slide the leg extension in one
direction or the other as far as the desired
position so as to obtain the required
platform height.
Lock the leg extension again using the
locking pin.
Platform height
above ground
in cm
60
65
70
75
80
85
90
b) Then adjust the other 3 legs in the same way
as for the first one.
c) Make sure that the platform is stable,
otherwise readjust the legs accordingly.
9
Max. working
Wheelbase AxB
height
in cm
in cm
260
140.5 x 69
265
145 x 69
270
150 x 69
275
154.5 x 69
280
159 x 69
285
164 x 69
290
168.5 x 69
Werbung
