Troubleshooting
Malfunction
Possible reason
The coffee machine does
The unit is unplugged from the
not switch on
mains
The unit is in the sleep mode
The coffee grinder is
The coffee grinder is clogged
making odd noises
There are foreign objects caught up
in the coffee grinder
The coffee grinder doesn't
The coffee grinder motor has
work
broken
There are foreign objects caught up
in the coffee grinder
Liquid is slowly leaking
The grind is too fine
from the coffee spout
The brewing unit is clogged up
Instead of coffee water
Coffee beans are not sufficiently
drips from the coffee
ground
supply block
Coffee beans are wet
The coffee machine
The brewing unit has been inserted
displays a notification that
incorrectly
there is no brewing unit
although it is installed in
the machine body
The coffee spout produces
The water supply system is clogged
too little coffee
with the residual scales
The milk is not frothing
The milk frother is clogged
The milk frother is installed
incorrectly
The frothed milk control knob (15)
is set to the position «Hot milk»
This type of milk is not suitable for
frothing
Milk is not flowing into the
The milk system has been clogged
frothing and supply system
The milk supply tube is installed
improperly
The coffee maker display
The coffee grounds container
shows the message that
sensor is blocked
the used coffee grounds
container is not installed,
though it is installed to its
place
Solution
Plug the coffee machine into the mains
Touch the ON button on the front panel
Clean the coffee grinder according to this guide
Unplug the coffee maker, remove foreign objects from
the coffee grinder and wipe it with a dry cloth.
Contact the service center
Unplug the coffee maker, remove foreign objects from
the coffee grinder and wipe it with a dry cloth.
Adjust the grinding by setting it to less fine grind
Clean the brewing unit following the guide
Adjust the coffee grinder settings to «+»
Replace the coffee beans with well-dried ones
Check the brewing unit and reinsert it in accordance with
this guide
Descale the coffee machine in accordance with this guide
Fully clean the milk system and milk tube.
Check the milk frother and reinstall it in accordance with
this manual
Turn the control knob (15) counterclockwise to the posi-
tion «Frothed milk»
For best results, use whole milk
Perform the complete cleaning of the milk system,
according to this manual
Recheck the installation of the milk supply tube, it should
be located below the upper edge of the milk in the
container
Remove the used coffee grounds container and thor-
oughly clean all corners of the container area with the soft
brush supplied with the unit, and clean all outer corners of
the container with a dry cloth.
36