Cleaning And Maintenance - Rondell Rde-1113 Die Betriebsanweisung

Setting the drink temperature
When you have finished setting the drink parameters,
press the «Menu/Ground coffee» button (22). Then
press the «+» (23) or «–» (27) button to adjust the
drink preparation temperature in the range of 75-95 °C
(pic. 32).
Auto switch-off timer setting
To save energy, you can set the timer to switch the
coffee machine off in the range from 1 to 24 hours.
To activate it, after setting the drink preparation tem-
perature, press the «Menu/Ground coffee» but-
ton (22). The message «E0» will appear on the dis-
play (18). It means that the auto switch-off timer is
off (pic. 33).
To set the desired switch-off time, use the «+» (23) or
«–» (27) buttons on the control panel (7). After com-
pleting the automatic switch-off setting, press the
«Menu» button (22) to go to the next section.
Setting the "Initialization" parameters
When you have finished setting the drink parame-
ters, press the «Menu/Ground coffee» button (22).
The message «INIT» will appear on the display (18)
(pic. 34).
– Press again the «Menu/Ground coffee» button
(22) to confirm the installed settings. The dis-
play (18) readings will switch to the standby mode
(pic. 8).
– Press the «+» button (23) to return to the factory
settings.
Drip Tray (1)
When the level of the drained liquid rises to the upper
limit, the float full tray indicator rises, after which it is
required to drain the liquid from the drip tray.
Brewing unit (12)
Please do not open the door (11) or move the brewing
unit (12) during coffee making. If the display (18) shows
the symbol «Install the brewing unit» (pic. 35),
please remove and then reinsert it until you hear a click-
ing sound.

CLEANING AND MAINTENANCE

Washing the milk supply system
After each drink with milk, it is necessary to clean the
coffee machine from its residues.
– Install the container for draining the liquid under the
coffee supply unit (2) of the coffee machine and
adjust its height (Fig. 5).
– Place the milk supply tube (31) on the milk system
inlet (3) and adjust its height (pic. 5).
– Put the tube in a container with clean water (pic. 17).
– Press the «Frothed milk» button (21).
– Repeat the procedure until the milk tube becomes
completely clean
– Drain the liquid from the tray (1).
Notes: We recommend washing the milk system after
each use.
ATTENTION! During the cleaning process, do not touch
the coffee supply unit (2) to avoid burns.
Flushing the milk frother
1. Press the locks of the milk frother (30) (Fig. 36) and
remove it from the coffee supply unit (2).
2. Put the frother into a container with warm clean water
for a while (pic. 37), then rinse it and dry it.
3. Put the milk frother back into the coffee machine
(Fig. 38).
Cleaning the coffee bean container
– Disconnect the unit from the mains.
– Open the coffee bean container lid (8) and clean the
inside of the coffee bean container (10) with a dry
soft cloth.
ATTENTION! Do not use water or sharp objects to
clean the container (10).
Cleaning the brewing unit (Fig. 39)
Note: We recommend cleaning the brewing unit once
a month.
1. Open the brewing unit compartment door (11).
2. Remove the used coffee grounds container (13).
3. Press the lock of the brewing unit and remove it
from the coffee machine. Lower the brewing unit
(12) for a while into a container with warm, clean
34