Storing Food; Reversing The Direction In Which The Door Opens; Necessary Tools - Veripart VPKV701 Benutzerinformation

• Always place the appliance on a moisture-resistant
and dry surface.
• Place the appliance on a firm and flat surface
(floor) so that it is stable, otherwise vibrations and
noise may occur. When placing the appliance
on floor coverings such as carpets, straw mats
or polyvinyl chloride (PVC), place a solid sheet
or cover under the appliance to prevent colour
change due to heat dissipation.
4. Clean
Before putting the appliance into use, clean the interior and all associated accessories with lukewarm water and
neutral soap. Dry everything carefully. Do not use solvents or abrasive powders; these may damage the coating.
5. Wait
On first installation (or after turning the door) wait at least four hours before plugging in the appliance. This allows
the oil to flow back into the compressor.
6. Switch on
Before plugging in the power cable, check that the voltage and frequency of the type plate match your power
supply network. Only connect the appliance to an earthed power socket. After one hour, open the door of the
appliance. If the temperature in the appliance is noticeably lower, this indicates that the cooling system is operating
normally.
7. Mounting accessories
- Adjustable shelves
The walls of the appliance are equipped with a series of guide profiles so that the
shelves can be inserted if desired.
- Installing the door compartments
To store food of different sizes, the door compartments can be set to different heights.
Proceed as follows: gradually pull the compartment in the direction of the arrows
until it comes loose and put it in the desired position.

8. Storing food

See Section 4 "Use".

3.2 REVERSING THE DIRECTION IN WHICH THE DOOR OPENS

To remove the door, the appliance must be tilted backwards. We recommend doing this with two people. Rest the
appliance on a firm surface so that it does not slip away as you reverse the door.
Keep all removed parts to remount the door later.
During this process, the appliance must be placed on its back. After this, wait four hours before connecting the
appliance so that the oil can flow back to the compressor.

Necessary tools:

• Crosshead screwdriver
• 8 mm socket spanner
• Flat head screwdriver
• 10 mm socket spanner
29