Husqvarna 325iLK Bedienungsanweisung Seite 15

operation condition requires full speed/full power, use
level 3. Do not use a higher level than necessary for the
operation.
1. Push the mode button to set a limit to the maximum
speed. The white LEDs comes on to show that the
function is on. (Fig. 39)
2. Push the Mode button again to choose the next
speed level.
Automatic shutdown function
The product is equipped with a shutdown function that
deactivates the product if it is not used.
Grass trimming with a trimmer head
To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. (Fig. 40) Do not push the grass
trimmer line into the grass.
2. Use 80 % speed when you cut grass near objects.
(Fig. 41)
To cut the grass
1. Make sure that the grass trimmer line is parallel to
the ground when you cut. (Fig. 42)
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously, it can cause damage to the trimmer
head.
Introduction
WARNING:
maintenance work you must read and
understand the safety chapter.
Maintenance
Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the cutting attachment is not damaged. Replace the cutting
attachment if it is damaged.
785 - 007 - 10.10.2023
Maintenance
Before you do any
4. Use full speed when you move the product from side
to side to cut grass. (Fig. 43) Make sure that the
grass trimmer line is parallel to the ground.
To sweep the grass
The airflow from the rotating trimmer cord can be used
to remove cut grass from an area.
1. Hold the trimmer head and its cord parallel to the
ground and above the ground.
2. Apply full speed.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING:
cover each time you assemble new trimmer
cord to prevent unbalance and vibrations in
the handles. Also do a check of the other
parts of the trimmer head and clean it if
necessary.
To stop the product
1. Release the power trigger or the power trigger
lockout.
2. Push the stop button. (Fig. 44)
3. Push the release buttons on the battery and pull the
battery out. (Fig. 45)
Maintenance schedule
WARNING:
you do maintenance.
The following is a list of the maintenance steps that you
must do on the product.
Clean the trimmer head
Remove the battery before
Daily Weekly Monthly
X
X
X
X
X
X
15