Caberg DRIFT EVO II Bedienungsanleitung Seite 9

WARNINGS! Any adjustments to the sun shield must be done in still position.
4. HOW TO REMOVE THE WASHABLE LINING
To remove the inner padding you can start from either the right or left
side.
4.1 Remove the cheek pad by pulling the red strap located on the front of
the cheek pads to detach from the three studs. Remove the straps
from both cheek pads and remove the two cheek pads along with the
neck protection.
4.2 Remove the lining by detaching the 2 studs on the rear side, then pull
it out gently by releasing the frontal fixing strips D. (Pic.5)
4.3 Pull out completely the lining.
5. HOW TO FIT THE WASHABLE LINING
5.1 Place the main liner padding inside the helmet.
5.2 Place the plastic frame in the front D and fix it to the seat attached to
the EPS liner. (Pic.6)
5.3 Hook the 2 studs in the rear side of the helmet.
5.4 cheek pad insertion: thread the strap inside the two cheek pads (Fig.
10). Insert the fixing strips E between the shell and EPS (Fig.7), lastly,
insert and fasten the three studs on the back of the cheek pads at the
top in their seats on the internal chin bar cover F. (Fig.11)
ENG
9