Herunterladen Diese Seite drucken

Caberg DRIFT EVO II Bedienungsanleitung Seite 3

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

4. Se il comunicatore è dotato di centralina BT separata,
alloggiarla nella tasca predisposta ricavata nella parte posteriore
della calotta interna.
4. If your COM has a separate BT controller, place it in the
designated slot on the back of the inner shell.
4. Si le communicateur est équipé d'une unité de commande
BT séparée, placez-la dans la pochette située à l'arrière de la
coque intérieure.
4. Si el intercomunicador cuenta con unidad BT separada,
colocarla en el bolsillo correspondiente situado en la parte
posterior de la calota interna.
4. Wenn die Gegensprechanlage mit einer separaten
BT-Steuereinheit ausgestattet ist, legen Sie diese in das
entsprechende Fach auf der Rückseite der Innenschale.
FULL FACE
DRIFT EVO II
4
5. Applicare il tastierino sul lato sinistro (casco indossato), a
circa 5 mm dal bordo inferiore della calotta mediante l'utilizzo
dell'apposito adesivo fornito. Verificare che ci sia piena
superficie di contatto tra il tastierino adesivizzato e la calotta
esterna.
5. Fit the keypad on the left side (helmet on), approximately
5 mm from the lower edge of the shell using the provided
adhesive. Make sure that there is full contact surface between
the adhesive keypad and the outer shell.
5. Fixer le clavier sur le côté gauche (dans le sens du casque), à
environ 5 mm du bord inférieur de la coque, à l'aide de l'adhésif
fourni. Vérifiez qu'il y a une surface de contact complète entre le
clavier adhésif et la coque extérieure.
5. Colocar los botones en el lado izquierdo (con el casco
puesto), a unos 5 mm del borde inferior de la calota con ayuda
del adhesivo suministrado. Comprobar que los botones con el
adhesivo estén totalmente en contacto con la superficie de la
calota externa.
5. Befestigen Sie das Tastenfeld mit dem mitgelieferten Kleber
auf der linken Seite (Helm auf), etwa 5 mm vom unteren Rand
der Schale entfernt. Vergewissern dass es eine vollständige
Kontaktfläche zwischen dem angeklebten Tastenfeld und der
Außenhülle gibt.
5

Werbung

loading