Installation Safety Precautions; Battery Safety - ECO-WORTHY NS24L30 Bedienungsanleitung

Installation Safety Precautions

WARNING: This unit does not contain GFDI device.
Mount the MPPT indoors. Prevent exposure to the elements and do not allow
water to enter the controller.
Install the MPPT in a location that prevents casual contact. The MPPT heatsink
can become very hot during operation.
Use insulated tools when working with batteries.
Avoid wearing jewelry during installation.
The battery bank must be comprised of batteries of same type, make, and age.
Do not smoke near the battery bank.
Power connections must remain tight to avoid excessive heating from a loose
connection.
Use properly sized conductors and circuit interrupters.
The grounding terminal is located at the bottom of the case.
The MPPT controller must be installed by a qualified technician in accordance with
the electrical regulations of the country of installation.
A means of disconnecting all power supply poles must be provided. These
disconnects must be incorporated in the fixed wiring.
The MPPT negative power terminals are common, and must be grounded as
instructions, local codes, and regulations require.
A permanent, reliable earth ground must be established with connection to the
MPPT ground terminal.
The grounding conductor must be secured against any accidental detachment.

Battery Safety

WARNING: A battery can present a risk of electrical shock or burn from large
amounts of short-circuit current, fire, or explosion from vented gases. Observe
proper precautions.
WARNING: Risk of Explosion. Proper disposal of batteries is required. Do not
dispose of batteries in fire. Refer to local regulations or codes for requirements.
CAUTION: When replacing batteries, use properly specified number, sizes,
types, and ratings based on application and system design.
CAUTION: Do not open or mutilate batteries. Released electrolyte is harmful
to skin, and may be toxic.
Servicing of batteries should be performed, or supervised, by personnel
0
0
2