Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.Then, press "Start/Pause" button to select
the desired programme.
Changing the programme after it
has started
You can use this feature to dry your clothes
under higher or lower temperatures after your
dryer has started.
For example;
1. Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to "Cancel"
the programme in order to select "Extra
Dry" programme instead of "Iron Dry"
programme.
2. Select the programme with the Programme
Selection button.
3. Press "Start/Pause/Cancel" button to start
the programme.
C
Child-proof lock of the machine should not
be active in order to perform this operation.
If the child-proof lock is active, deactivate it
before performing these operations.
Adding/removing laundry in
standby mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to start
the programme.
C
Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C
Laundry may be added or taken out as
much as desired during a drying process,
but as this process will interrupt drying
continuously, it will extend the programme
duration and increase energy consumption.
Therefore, it is recommended to add laundry
before the drying programme has started.
Child-proof lock
There is a child-proof lock to prevent any
programme interruption due to the pressing of
button while the programme is running. The
loading door and all buttons except the "On/
Off" button on the control panel are deactivated
when the child-proof lock is active.
In order to activate the childproof lock, press
End Time "-" and Programme "+" buttons
simultaneously for 3 seconds. "CL3-CL2-CL1"
and "on-CL-on" appears on the display and the
function is activated.
To start a new programme after the programme
is over or to interrupt the programme, the child-
proof lock should be deactivated. Press the
same buttons for 3 sec. again to deactivate the
child-proof lock. "CL3-CL2-CL1" and "oFF-CL-
oFF" appears on the display and the function is
deactivated.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/Off
button.
C
Press the relevant buttons for 3 seconds to
activate the child-proof lock. A long beep
will be heard and the child-proof lock will be
activated. A double beep will be heard if you
press any button when the child-proof lock
is active. Press the buttons for 3 seconds to
deactivate the child-proof lock. Single beep
will be heard and child-proof lock will be
deactivated.
Ending the programme through
canceling
In order to cancel the selected program;
press "Start/Pause/Cancel" button for about 3
seconds.
A
As the inside of the machine will be
excessively hot when you cancel the
programme while the machine is running,
activate the ventilation programme to cool
it down.
End of programme
"End" appears on the display and "Filter
cleaning" and "Water tank" warning lights turn
on when the programme is over. The door can
be opened and the machine becomes ready for
35 EN
Werbung
