3L STAR WELD TEC-800 Montageanleitung Seite 6

EN
REPLACING FRONT COVER LENS
Replace the front cover lens if it is damaged. Remove ADF holder assembly per fig.6. Remove front cover lens from hel-
met assembly. Carefully remove gasket from cover lens. Install new cover lens into gasket and assemble to helmet shell.
ES
Make sure to assemble cover lens and gasket into helmet shell the same way as it was removed.
REPLACING INSIDE COVER LENS
Replace the inside clear lens if it is damaged. Place your fingernail in recess below cartridge view window and flex lens
upwards until it releases from edges of cartridge view window.
CHANGE THE SHADE CARTRIDGE
DE
Remove ADF holder assembly from helmet shell. See fig.7 for removal. Flex top end of the ADF holder to allow for ADF
cartridge to be removed from frame. Install new ADF cartridge into frame per fig.7 below. Make sure that the ADF cartri-
dge is inserted in ADF holder correctly as shown. Install ADF holder assembly into helmet shell.
FR
GR
Optical Class
Viewing Area
PL
Cartridge Size
Arc Sensor
Light State
Shade
Shade Control
Power On/Off
PT Sensitivity Control
UV/IR Protection
Power Supply
Low Battery Warning
Switching Time
Delay (Dark to Light)
Low Amperage TIG Rated ≥ 5 amps / DC; ≥ 5 amps / AC
RO
Grinding
Operating Temp.
MAINTENANCE
TECHNICAL SPECIFICATIONS
1 / 1 / 1 / 2
98x44mm (3.86"x1.73")
110x90x9mm (4.33"x3.54"x0.35")
2
DIN 3.5
DIN 9 ~ 13
Internal,Variable Shade
Fully Automatic
Adjustable by dial knob
Up to Shade DIN16 at all times
Solar cell. Battery replaceable, 2 x AAA Alkaline batteries
Red Light
1 /16,000 s. from Light to Dark
0.1 ~ 1.0s by dial control knob
Yes
-10°C ~ +55°C (14°F ~ 131°F)
6