Bestway AquaTronix G200 Gebrauchsanweisung Seite 3

- Green Light: Robot is running
- Blinking Green Light: Switch is on but the robot is out of the water
- Blinking Red Light: Battery will be empty in 10 minutes.
• When the robot starts charging, the indicator light will blink red. When the robot is fully charged, the
indicator light will turn green.
• To adjust the float length, release enough rope from the float to cover the depth of pool water plus about
0.5 m (19.7").
• If float is too far to be retrieved by hand, use the provided hook. Place the hook on a telescopic pole
(not included) and then use the hook to retrieve the float.
• lt's advised to turn off the filtration system as water circulation in the pool may affect the robot's movement
pattern.
• Remove the pool ladder, surface skimmer and other floating objects from the pool, as it may obstruct
the movement of the robot's float and, consequently, also the movement of the robot.
• lf you are using a saltwater pool, make sure all salt is dissolved before placing the robot into the water.
MAINTENANCE AND STORAGE
• Battery will lose charge during storage. Make sure to fully-charge the robot before storage.
• You must re-charge the battery at least once every three months when it is not in use.
• Unplug the external adaptor from the socket and then unplug the charging cable from the external
adaptor and robot.
• Detach accessories from the robot. lf necessary, rinse the robot and accessories with fresh water.
DO NOT use detergent.
• Ве sure to drain the water from the robot before storing it.
• Use а damp cloth to clean and dry the robot and its accessories.
• We strongly recommend disassembling the product during the off-season (winter months) and storing
it in a dry place with a moderate temperature between 10ºC/50ºF and 38ºC/100ºF.
NOTE: А higher storage temperature may reduce the battery life.
TROUBLESHOOTING
Problem
The robot cannot
capture debris, or it
moves slowly or does
not move at all.
The robot stops moving,
but the swivel head is
still rotating.
The swivel head does
not work or cannot
stop working.
The robot works
around the pool wall
and cannot cover the
whole pool.
The robot fails to
charge.
Probable Cause
Low battery.
The debris compartment is filled, or the debris
screen is blocked.
The impeller is stuck or broken.
The debris compartment is filled, or the debris
screen is blocked.
The robot is jammed by debris on the bottom.
The swivel head is stuck.
The swivel head fails to work.
The flapper is stuck.
The debris compartment is filled, or the filter is
blocked.
Improper locking adjustment position.
The battery is damaged.
The charger is jammed by debris.
The adapter does not work.
Charge the robot.
Clean the debris compartment or the debris
screen.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
Clean the debris compartment or the debris
screen.
Check and remove any debris.
Check and remove any debris that is trapped
under the swivel head or the rotating robot head.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
Check and remove any debris that hinders the
movement of the flalpper.
Clean the debris compartment or the filter.
Follow Step 3 in the diagrams for proper locking
adjuster position.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
Check and clean any debris.
For assistance, please visit the support section
on our website, www.bestwaycorp.com.
3
Solution