Bestway AquaTronix G200 Gebrauchsanweisung Seite 2

EN
WE SUGGEST NOT TO RETURN
THE PRODUCT TO THE STORE
QUESTIONS? PROBLEMS?
MISSING PARTS?
For FAQ, Manuals, Videos Or
Spare Parts, Please Visit
bestwaycorp.com/support
IMPORTANT SAFETY INSTRUCTIONS
WARNING
• If instructions is missed, please contact with Bestway or search it in website: www.bestwaycorp.com.
• The appliance is only to be used with the adaptor (JOD-S-090200GS-2) and
(JOD-S-090200BS-2). The adaptor (JOD-S-090200GS-2) is for European country except UK, the
(JOD-S-090200BS-2) is for UK.
• Disconnect the pump from the supply mains before carrying out user maintenance such as cleaning
the filter.
• Always disconnect the appliance from the supply before assembling, disassembling or cleaning.
• Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and if they understand the hazards involved.
• Pumps without indication that they are protected against the effect of freezing shall not be left outside
during freezing weather conditions.
• This appliance shall not be used by children.
• Cleaning and User maintenance shall not be carried out by children.
• Children shall not play with the appliance.
• This appliance contains batteries that are non-replaceable.
• Pool Vacuum: 9.0Vd.c. 2.0A IPX8
• Adaptor (JOD-S-090200GS-2) and (JOD-S-090200BS-2)
• Input: 100-240V~50Hz/60Hz 0.5A Class II
• Output: 9.0Vd.c. 2.0A 18.0W
DISPOSAL
Electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your local authority or retailer for recycling advice.
ASSEMBLY AND OPERATION
• The robot will stop during use in the following pool conditions:
- The bottom of the pool is folded
- The pool was installed on uneven, unlevel or bumpy ground
If the bottom has a large amount of debris, it is recommended to empty the basket after 10 minutes of
use to optimize the robot's performance.
• Use only the original external adaptor and provided charging cable.
• Make sure the robot and the charger port are clean and dry before charging.
• Make sure that the robot is turned off by sliding the switch to the OFF position prior to charging.
• Fully charge the robot (about 5-6 hrs) before using it for the first time.
• Power Indicator light:
- No Light: Switch is off, or battery is empty
OWNER'S MANUAL
58765
Visit the Bestway YouTube channel
2