Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. Cut the damaged sensor from
the wire.
3. Put thin copper tubes on to
tighten the cores.
5. Cut the sensor connectors to
make it 5mm long.
7. Heat the heat-shrinkable
tubes with a lighter.
9. Put on a large heat-shrinkable
tube and heat it with a lighter.
Specifications
Application
Distance
Cable length
Waterproof probe
Operating frequency
Auto-off
Operating temperature range
Power source
Battery life
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.
Care and maintenance
Do not exclusively rely on the detector to locate items behind scanned surfaces. Do not try to disassemble the device on your own for any
reason. For repairs and cleaning of any kind, please contact your local specialized service center. Protect the device from sudden impact and
excessive mechanical force. Store the device in a dry cool place. Only use accessories and spare parts for this device that comply
with the technical specifications. Never attempt to operate a damaged device or a device with damaged electrical parts! If a part of the
device or battery is swallowed, seek medical attention immediately.
Battery safety instructions
Always purchase the correct size and grade of battery most suitable for the intended use. Always replace the whole set of batteries at one
time; taking care not to mix old and new ones or batteries of different types. Clean the battery contacts and also those of the device prior
to battery installation. Make sure the batteries are installed correctly with regard to polarity (+ and –). Remove batteries from equipment
that is not to be used for an extended period of time. Remove used batteries promptly. Never short-circuit batteries as this may lead to high
temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Remember to switch off
devices after use. Keep batteries out of the reach of children, to avoid the risk of ingestion, suffocation, or poisoning. Utilize used batteries
as prescribed by your country's laws.
2. Peel off 5mm of insulation
from the wire.
4. Put small heat-shrinkable
tubes on.
6. Insert the sensor connectors
into the copper tubes using
pliers. Heat-shrinkable tubes
must cover the copper tubes
with the sensor tips inside.
8. Put on the protective cover
and put a drop of 502 glue.
10. The sensor replacement is
completed.
PVC/plastic/steel/copper/cement/iron pipes
non-metal pipe: 0–400mm / metal pipe: 0–150mm
20m
IP67
300Hz
transmitter: 1h
receiver: 30min
+10...+40°C (operating), –10...+50°C (storage)
+50...+104°F (operating), +14...+122°F (storage)
transmitter: 3.7V, 2600mA∙h built-in lithium battery (18650)
receiver: 3.7V,1400mA∙h built-in lithium battery
5V, 1A DC adapter (not included)
dual Type-C USB-cable (included)
transmitter: 10h
receiver: 5h
4
Werbung
