cecotec READYWARM 2070 MAX DUAL WHITE Bedienungsanleitung Seite 37

- Fully extend the power cable and plug it into the power outlet.
- To avoid overloading the circuit, check that no other appliances are connected to the
same unit.
- Turn the thermostat knob clockwise to the maximum position.
Switch on the heater by turning the control knob to one of the following three positions:
- fan only (thermostat always at maximum)
- heating at medium power (900W/1000W)
- heating at maximum power (1800W/2000W).
- The light on the front will turn on.
- It is most economical to heat the space at maximum power and then switch to medium
power to maintain the temperature.
- Both at medium and maximum power, the fan rotates at the same speed. The difference
between the two lies in the number of heating elements in use.
- Once the desired temperature has been reached, slowly turn the thermostat knob
backwards until you hear a click. The temperature is now set. The heater will
automatically switch on and off to maintain the selected temperature.
- When the heater is switched off, the pilot light will also go out.
- To set a higher or lower temperature, turn the thermostat knob clockwise or
counterclockwise.
- To turn the heater off, turn the thermostat knob to "O" (off). The pilot light will go out. The
pilot light indicates that the heater is switched on, not that it is connected to the mains.
- Unplug it.
Protection against overheating
- In case of internal overheating, the protection against overheating will turn off the heater.
This may occur if the heater cannot emit enough heat or if it cannot draw in enough fresh
air.
- As mentioned above, this is often caused by (partially) covering the heater, obstructing
the air inlet and outlet grilles, or installing the heater too close to a wall or similar. When
the protection against overheating switches the heater off, turn the thermostat knob to
"O" (off), unplug the heater and allow it to cool down. Eliminate and/or modify the cause
of the overheating and return the heater to normal operation. If the cause is not found
and overheating occurs again, stop using the heater and have it checked/repaired.
READYWARM 2070 MAX DUAL WHITE
ENGLISH
37