Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
1. In order to ensure that the product can be used safely for a lang time, the product
must be installed on a perfectly sturdy surface, and the electronic components must
be isolated to prevent the possibility of contact with metal accessories.
2. The kitchen cabinet where the product is installed and all adhesives used must be
able to withstand a temperature of not less than 90
cracking.
3. Before connecting to the power source, make sure:
• According to regulations, there should be an ground system. The socket and circuit
connected to the power supply must be reliably grounded.
•After installation, the control buttons are easily accessible and operable.
• After the product is connected to the power source, please check whether the power
cord is in contact with heat-prone accessories. lf there is contact, move it away to a safe
distance.
• Do not use reducers, shunts and adapters that can cause overheating or self-ignition.
The manufacturer is not responsible for any direct or indirect lasses caused by incorrect
installation or connection of any electronic components. Therefore, all installation
and connection operations must be performed by qualified technicians following
local regulations.
• DO NOT connect the ground wire to gas pipes, water pipes, lightning rods and telephone
lines to avoid accidents caused by electric shock due to poor grounding. The socket
should not be installed in a place exposed to moisture, water or near a heat source.
4. When installing electrical appliances, be sure to wait until the installation is complete
before turning on the power source.
This product is equipped with a power cord approximately 1.2 meters lang. Users
are required to use a 16A socket, and the socket must be connected to a leakage protection
switch.
°
C to avoid deformation and paint
05
Installation Method
m
"' "'
"'
Lowcabinet
installation
/'--�------J_ ___ )
Mounting screw fixing position
• Open the oven door and use the self-tapping
screws to fix the prod uct onto the kitchen
cabinet (there are self-tapping screw holes on
both sides of the front panel of the product).
Make sure that the product is firmly fixed, so
that the product will not slant forward and
damage the contents in the oven du ring use.
• Please refer to the diagram below when
installing the product, ensure that the product
has enough installation space and adequate
ventilation.
m
unit:mm
TopView
�g�
'--ao!
'
�r
SideView
543
'
iil
ii
J
D
II
II
.
�:
.c_ll
06
"'
;;';
l+-i
0
(D
N
l/l
� C
IJQ
IJQ
....
(D
(D
0..
0
....
c-,
<lJ
o·
Werbung
