Candy CMCL 5142SN Bedienungsanleitung Seite 19

To contact the technical assistance, visit our
website:https://corporate.haier-europe.com/en/
Under the section "website", choose the brand of
your product and your country. You will be
redirected to the specific website where you can
find the telephone number and form to contact the
technical assistance
I. Maintenance guide
a) Sensor fault alarm:
If any sensor fails, the corresponding LED indicator
will flash at a frequency of 1Hz (i.e., ON for 0.5s,
OFF for 0.5s), until the said fault gets removed:
• Indicator light '2°C' flashing : fridge
temperature sensor fault
• Indicator light
evaporator sensor fault
• Indicator light '8°C' flashing: ambient
temperature sensor fault
b) Door open alarm
If the fridge door is left open for more than 3
minutes, all the indicator lights get flashing
simultaneously at the frequency of 1Hz (i.e., ON for
0.5s, OFF for 0.5s). The alarm can be suspended for
3 minutes by pressing any key, however it will not
be lifted until the said fridge door is closed.
The compressor cannot start.
If a power failure occurs, please wait for 5 minute
before turning on the appliance or wait for 5
minutes after the system is powered on. After that
observe whether the compressor can work
normally or not.
The refrigerator has frost formation
It is normal, this is not a no frost appliance.
If there is heavy frost in the freezer compartment,
please defrost the appliance (see "maintenance
and cleaning" section).
Certifications
Electrical information
This electrical appliance must be grounded
This product is equipped with a plug, which is
suitable for all houses equipped with sockets
meeting the current specifications
If the fitted plug is not suitable for your socket
outlets, it should be cut off and carefully disposed
'5°C' flashing: fridge
of. To avoid a possible shock hazard, do not insert
the discarded plug into a socket.
This product complies the EEC directives.
Reversing the Door Swing
1. Make sure that your refrigerator is unplugged.
2. Pry the hinge cover up and off, remove the three
screws that secure the upper hinge to the door,
then remove the hinge.
3. Remove the refrigerator compartment door
from the cabinet.
4. Remove the two screws that secure the center
hinge.
5. Remove the freezer compartment door.
6. Remove the screws that secure the lower hinge
to the right side of the cabinet, then remove the
hinge.
7. Remove the washer and nut that secure the pin
shaft to the right hole on the lower hinge, then
remove the shaft
17
Hinge cover
Screws
Upper hinge
Refrigerator compartment
door
Center hinge
Screws
Center hinge
Screws
Pin shaft