Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Reset
Disconnect the terminals TaK - TbK,
TaM - TbM at the BVSG, then
disconnect the power. When
restoring the power, hold the "Prog.
Mode" button down for 3 seconds.
Now wait until the BSG has fully run
up, and only then reassign the
terminals TaK - TbK, TaM - TbM. The
BVSG will the start to reboot again.
This completes the reset process.
Exchanging the BTLM 650-02/
BTLE 050-02 .
When exchanging the BTLM 650-02/
BTLE 050-02 , the call buttons must
always be completely repro-
grammed.
Wiring diagram
AS-TVH-1/1
Remarks
2) With the TR 602-..., pay attention
to the total load which can occur
simultaneously.
4) The VNG 602-... is only required
if the MOM/MOC 711-... is used
with ZWM 711-... or with the
MOCT 711-... and when connecting
two MOM/MOC/MOCT 711-... units
in parallel.
5) For the internal wiring of the door
loudspeaker, see the product
information BVSM 650-... .
6) For the internal wiring of the
combination BTS/BTC 750-... with
BVE 650-... and MOM/MOC/
MOCT 711-..., see product infor-
mation BVE 650-...
Commissioning
and programming
Commissioning
Setting the address
Fig. 1
Each address has to be set only once
in the system.
System start
Fig. 2 and 3
LED is blinking until the system is
operational.
Programming
Switching on the programming
mode
Fig. 4
Activating the BTLM
Fig. 5a
Activating the BTLE
Fig. 5b
Activating the BT
Figs. 6 to 8
Assigning the call buttons
Fig. 9 and 10
Checking
Figs. 11 to 14
!
Only press the call button
briefly (< 2 secs.) as otherwise
the call button will be deleted again.
Parallel operation of the 2 BTs
Activating the 1st BT: Figs.. 15 to 17
Activating the 2nd BT: Figs.18 to 20
Assigning call buttons
Fig. 21 and 22
Switching off programming
mode
Fig. 23 and 24
7
Werbung
