clage Zip HydroTap G4 BC 100/75 Gebrauchsanleitung Seite 36

LCD Screen operation - Section F
Note:
Any attempt, during OFF mode, to dispense water, will bring
the unit out of energy mode. The system will revert to the energy
mode setting after 30 minutes of non use.
Safety
To allow the safety setting to be changed
1. Press the [MENU] button for
main menu.
2. Press the [Setting] button.
3. Press the [Safety] button.
4. Press button A to allow the
safety setting to be changed.
Hot Isolation
The HydroTap is equipped with a safety mode that allows for addi-
tional safety protection, if needed.
To Activate the Hot Isolation
1. Press button C to enable hot isolation.
2. Then tap the safety lock three times rapidly, the LED's will scroll
from right to left three times and the hot isolation will be active.
3. To de-activate, press button C to disable hot isolation.
To operate the tap when in Hot Isolation mode, tap the Safety Lock
three times rapidly, the LED's will scroll from right to left three
times. This operation confi rms de-activation and will remain de-ac-
tivated for 30 seconds. The Hot Isolation can be immediately set
again, by tapping the safety lock three times rapidly.
NOTE: Upon completion, all the settings can be protected by
dis-allowing any setting changes by selecting [NO] on the menu
screen.
A
Group set
1. Press group set option 1 / 2
2. Press button A to enable /
disable group set. When the
enable box is ticked, this allows
each individual day to have an
"On/Off "time.
3. Then press the [ON/OFF
Modes] button, to set up ON/
OFF time.
36
A
B
C