Settings; Device Information - Gold Note IS-10 Bedienungsanleitung

| SETTINGS

Select the gear icon
once to access the settings. Turn the SKC to
browse the settings, press it once to adjust
the highlighted setting.
To exit the menu, select BACK and press the
SKC once.
DISPLAY
Rotate the SKC until the DISPLAY setting
is highlighted, then press the SKC once to
select it.
Rotate the SKC to choose the desired
brightness, then press it once to confirm.
The brightness can be set to:
|
100%
|
50%
|
25%
|
OFF
When the display is set to OFF, use the SKC
or press a button on the remote to activate it
again for 3 seconds.

DEVICE INFORMATION

Push the SKC once to view the device
information, such as:
|
Model
|
Serial number (S/N)
|
Firmware version (FW VERSION)
|
IP address (IP, only when the IS-10 is
connected to the network).
FACTORY RESET
Select OK to reset the unit or CANCEL to
exit the menu.
The unit goes on standby after each reset.
and press the SKC
11
SETTINGS
DISPLAY
DEVICE INFORMATION
FIRMWARE UPDATE
FACTORY RESET
BACK
DISPLAY
Normal
DISPLAY
Highlighted
DISPLAY
Selected
DEVICE INFO
MODEL:
S/N:
FW VERSION:
IP:
BACK
OK CANCEL
100%
100%
100%
100%
IS-10