Bego Otoflash Gerätedokumentation Seite 29

Operation‒ Use with timer
1 2 3
Fig. 4 Front side
Setting the timer
8
The device is switched on with the power switch (1),
the green indicator labelled "Ready" (7) will light up
and a 4-digit figure will appear on the display (4).
This figure indicates the number of flashes. The
number of flashes can be programmed any number
between 0 and 9999 by pressing the buttons 1000,
100, 10 and 1.
4 5 6 7
Operating mode
The program is started by pressing the start button
(5). The timer will start to count down with every
flash. When the programmed number of flashes
have been completed, an acoustic signal will sound
three times and the word "End" will appear on the
display. Afterwards, the timer will be set to the
initially programmed number of flashes again. If the
lid is opened during the process, the entire device
will immediately be disconnected from the power
supply (except the timer), the word "open" appears
on the display and a long acoustic signal will sound.
Thus,the program can be interrupted at any time by
opening the lid. When the lid is subsequently closed
again, the program will return to the initially
programmed number of flashes.
Error message
The red field on the display labelled lamp (6) will
light up if one or both of the flash bulbs are
defective.
English ⋅ Otoflash
en
25