AEG IKE95771FB Benutzerinformation Seite 92

function. To change the heat setting use
the left front control bar only. The left
rear control bar is deactivated while the
function operates.
In some models there are two flexible
cooking areas, left and right. To operate
PowerSlide on the right side, use the
right front control bar.
Use only one pot with a minimum bottom
diameter of 160 mm when you operate
the function.
1. Place the correct cookware on the left
front side of the cooking area.
2. Press and hold
A signal sounds and indicators above
appear.
3. Press to activate the function.
A signal sounds and an indicator above the
symbol appears.
4. Move the cookware back and forth on the
cooking area as needed.
The heat setting level on the control bar
adjusts automatically.
5. To change the default heat setting levels,
move the cookware to the area you want
to adjust first.
6. Press any of the available heat setting
levels on the left front control bar.
The updated heat setting levels will be
remembered for the next time you use the
function.
7. Repeat the procedure for the remaining
cooking areas, if needed.
8. To deactivate the function, press
can also press 0 on the left front control
bar.
92 ENGLISH
to activate the hob.
and
. You
A signal sounds and the indicator above the
symbol disappears. The heat setting level
changes to 0.
You can set a timer while PowerSlide
operates. In this case the timer does not
deactivate the cooking zones when the set
time runs out. The timer affects all three
cooking areas activated by the function at the
same time.
7.7 Hob²Hood
It is an advanced automatic function which
connects the hob to a special hood. Both the
hob and the hood have an infrared signal
communicator. Speed of the fan is defined
automatically on basis of mode setting and
temperature of the hottest cookware on the
hob. You can also operate the fan from the
hob manually.
For most of the hoods the remote system
is originally deactivated. Activate it before
you use the function. For more
information refer to hood user manual.
Operating the function automatically
To operate the function automatically set the
automatic mode to H1 – H6. The hob is
originally set to H5. The hood reacts
whenever you operate the hob. The hob
recognizes temperature of the cookware
automatically and adjusts the speed of the
fan.
Automatic modes
Automat‐
ic light
Mode H0 Off
Mode H1 On
3)
On
Mode H2
Mode H3 On
Mode H4 On
Mode H5 On
Boiling 1) Frying 2)
Off Off
Off Off
Fan speed Fan speed
1 1
Off Fan speed
1
Fan speed Fan speed
1 1
Fan speed Fan speed
1 2