AEG IKE95771FB Benutzerinformation Seite 89

To activate the function: press
set any heat setting. Press and hold
seconds, until the indicator above the symbol
appears. Deactivate the hob with
The function stays active when you
deactivate the hob. The indicator above
is on.
To deactivate the function: press
not set any heat setting. Press and hold
for 3 seconds, until the indicator above the
symbol disappears. Deactivate the hob with
.
Cooking with the function activated: press
, then press for 3 seconds, until the
indicator above the symbol disappears. You
can operate the hob. When you deactivate
the hob with the function operates again.
7.5 Bridge
The function operates when the pot
covers the centres of the two zones. For
more information on the correct
placement of cookware refer to "Using
the cooking zones".
This function connects two right side cooking
zones and they operate as one.
First set the heat setting for one of the right
side cooking zones.
To activate the function: touch
change the heat setting touch one of the
control sensors.
To deactivate the function: touch
cooking zones operate independently.
7.6 Flexible induction cooking area
WARNING!
Refer to Safety chapters.
. Do not
FlexiBridge function
for 3
The flexible induction cooking area consists
of four sections. The sections can be
. combined into two cooking zones with
different size, or into one large cooking area.
You choose the combination of the sections
by choosing the mode applicable to the size
of the cookware you want to use. There are
three modes: Standard, Big Bridge, and Max
Bridge.
. Do
To set the heat setting use the two
control bars on the left side.
Switching between the modes
To switch between the modes press
heat setting levels will be kept.
In some models there are two flexible
cooking areas, left and right. To operate
the flexible cooking area on the right
side, use the symbols and the control
bars on the right side of the hob.
Diameter and position of the cookware
Choose the mode applicable to the size and
. To set or
the shape of the cookware. The cookware
should cover the selected area as much as
possible.
. The
Place the cookware with the bottom diameter
smaller than 160 mm centrally on a single
section. You can use a roaster pan for the Big
Bridge and the Max Bridge modes.
. The
ENGLISH 89