AEG IKE95771FB Benutzerinformation Seite 91

Incorrect cookware position:
FlexiBridge Max Bridge mode
To activate the mode press
the correct mode indicator
connects all sections into one cooking area.
To set the heat setting use any of the two
control bars on the left side.
Correct cookware position:
Make sure to place the cookware on the four
connected sections. If you use cookware
smaller than three sections the control bar
blinks and after 2 minutes the zone switches
off.
until you see
. This mode
Incorrect cookware position:
PowerSlide
This function allows you to adjust the
temperature by moving the cookware to a
different position on the induction cooking
area.
• The function divides the induction cooking
area into three areas with different heat
settings. The hob detects the position of
the cookware and adjusts the heat setting
corresponding with the position.
• You can place the cookware in the front,
middle or rear position. If you place the
cookware in the front you get the highest
heat setting. To decrease it, move the
cookware to middle or rear position.
• When you activate the function for the first
time you will get the following default heat
settings: 9 for the front position, 6 for the
middle position and 3 for the rear position.
• You can change the heat settings for each
position separately. The hob will
remember your heat settings next time
you activate the function.
• The heat setting display of the left front
control bar shows the heat setting for this
ENGLISH 91