Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
The energiser does not respond to commands from the Remote Control Handset.
·
Ensure you have a P4600 or P6000.
The P4500 does not respond to commands from a remote control handset.
·
Ensure that the remote contact on the Remote Control Handset is in contact with the fence wire
before pressing
remote control work better). After pressing
message to disappear from the display, as the energiser may send out a final pulse after
receiving the command to deactivate. Similarly, allow two seconds for the energiser to send
out its first pulse after receiving the command to reactivate.
·
If the battery symbol is displayed on the Remote Control Handset, replace the 9 V
alkaline battery and try again.
·
Rusty or oxidised wire can hamper the quality of the signal you receive. To obtain a clear signal,
rub the Remote contact against the fence wire to break through the layer of rust or oxidation.
·
Ensure that no gates or cut-out switches have been left open.
·
Sometimes the remote control will work in spite of minor breaks in the wire, although
reliable operation under such conditions is not guaranteed.
·
Check for spark gaps and loose wire joints in the fence. Severe or multiple spark gaps reduce
the effectiveness of the remote control.
·
Use the fault finding function of the remote control to locate faults in the fence line.
·
Check all connections to the fence and the earth system. Ensure that the energiser is
connected to the power supply and the fence system and that the energiser is switched on.
·
Try turning the energiser on and off by holding the Remote contact against the lead-out wire, or
by holding the remote control close to the energiser (within 15 to 30 cm) pressing the respective
button.
·
If the energiser still does not respond, then the remote control and energiser may have different
address settings. See "Changing the address setting of the remote control handset" on page 61
and "To activate the remote control feature on the energiser", page 60.
I want to disable the remote control feature.
If you have a remote control handset, see the remote control handset's user manual.
If not, take the energiser to an authorised dealer to have the feature disabled.
The energiser sometimes turn off unexpectedly
·
An adjacent property may have an energiser operating at the same address setting.
See, "Changing the address setting", page 61.
If the problem persists, seek advice from your PATURA dealer.
or
(Holding the button down for an extended period will not make the
or
wait for two seconds for the ON or OFF
71
Werbung
