Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Montageanleitung / Instructions de montage
Installation Instructions / Montagehandleiding
Indicaciones de montaje
Battery selection and management
This section refers exclusively to rechargeable, lead-acid batteries, for example car, tractor, truck,
marine or special deep-cycle batteries. The size of battery you select will depend on the model of
energiser you have and the selector switch position you use most frequently. Refer to "Operation"
on page 50 for an explanation of the function of the selector switch.
Battery selection
As a guide, the recommended battery size in amp hour (Ah) required for each energiser model
is shown below. This table is based on a 7 day operating period between battery charging.
Although operating time can exceed 7 days, this is likely to cause battery damage and will
necessitate frequent replacement of the battery.
For best system reliability and long term battery life, the preferred battery and charging regime
is to use a deep-cycle, lead-acid battery and to recharge it when it is half discharged.
For more information see "Battery Test setting" on page 57.
Selector switch position
Battery test
Slow Speed – Day
Fast Speed – Night
Fast Speed – Day
Slow Speed – Night
Half power
Full power
Warning! 12 V rechargeable lead-acid batteries must be used.
Battery management
Warning! Batteries contain harmful chemicals and when used incorrectly, may cause injury.
Observe the guidelines for battery care, maintenance and safety in the documentation
supplied with your battery.
Battery charging
Warning!
·
Do not attempt to recharge a non-rechargeable battery.
·
When recharging a battery, ensure that there is adequate ventilation to allow gases to disperse.
Current required
P4500/P4600
410 mA
530 mA*
1000 mA*
*(24 hours average)
530 mA*
1000 mA*
*(24 hours average)
330 mA
650 mA
P6000
P4500/P4600
750 mA
150 Ah
190 Ah
190 Ah
580 mA
120 Ah
1250 mA
230 Ah
Battery capacity
P6000
230 Ah
300 Ah
300 Ah
200 Ah
360 Ah
61
Werbung
