Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2.4 OPERATION
Connect the cooler to the electrical grid, bearing in mind the preventive/restrictive measures mentioned, and
turn the switch to On or I, the switch light should come on.
Control Panel with switch and thermostat
2.5 PRODUCT LOADING
WARNING: In case of a fault, do not approach the cooler barefoot, when the floor is wet or with wet
hands.
Turn on the cooler (see point 2 .3) and leave it to operate empty without interruption at least during the first
drop in temperature. The interior temperature must be within the previously mentioned interval before loading
the product. Place the product inside the cooler leave sufficient space between the cans or bottles.
Do not load the bottle cooler above the loading level.
Once loaded, avoid, as far as is possible, the frequent opening of the doors and, especially, do not leave them
open.
3. GENERAL MAINTENANCE
3.1 CLEANING
WARNING: Before carrying out any cleaning operation, the unit must be unplugged and the main switch
turned to the OFF or O position.
The cooler must be cleaned after unpacking and before plugging in. Bear in mind the following guidelines:
-
Use water and non-abrasive neutral detergent (do not use abrasives or chlorine products).
-
Clean with a cloth or sponge. Dry afterwards.
-
Frequency: Weekly (recommended)
3.2 REPAIR
If the unit needs repair, it should be done outside the establishment or premises, with the exception of electrical
elements. All repairs must be carried out by specialist and approved technicians, and in accordance with all the
manufacturer's recommendations. Do not remove the protection from the moving elements without having
previously unplugged the unit from the electrical supply.
WARNING: If the power cable is damaged, it must be replaced by the manufacturer or after-sales service
or similar qualified persons to prevent any risks.
www.combisteel.com
6
Werbung
