Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1. GENERAL INFORMATION
1.1 GENERAL CONDITIONS
This manual provides you with the information necessary for the installation, use and maintenance of the cooler.
Please read this instruction manual carefully before carrying out any operation. The manufacturer will not accept
any liability if the user does not follow these instructions.
1.2 RESTRICTIONS ON USE AND MAINTENANCE
This cooler has been designed to cool and store drinks in bottles or cans. Any other use is considered IMPROPER.
The machine must not be used outdoors, and must be protected from rain and direct sunlight. The manufacturer
is not responsible for other operations not mentioned in this manual, and all the recommendations and warnings
should be complied with.
WARNING:
This equipment can be used by children who are 8 years old and above and people with reduced physical, sensory
or mental capabilities or who lack experience and knowledge, if they are appropriately supervised or trained in
the safe use of the unit and understand the dangers involved.
The cleaning and maintenance to be carried out by the user should not be done by unsupervised children.
Children should be supervised to ensure that they do not play with the unit.
WARNING: Keep the ventilation openings clear around the unit or the built-in structure.
WARNING: Do not use mechanical devices or other means to accelerate the defrosting process, other
than those recommended by the manufacturer.
WARNING: Do not damage the cooling circuit.
WARNING: Do not use electrical apparatus inside the compartments intended for preservation of food,
unless they are of a type recommended by the manufacturer.
WARNING: Do not store explosives substances in this unit, such as aerosol cans with a flammable
propellant.
1.3 QUALITY CONTROL
This cooler is certified in accordance with our Quality Control Test.
1.4 USER RESPONSIBILITIES
-
Ensure that the floor is flat, this machine is levelled and the door closes properly.
-
Before connecting the bottle cooler to the power socket, check that the grid voltage and frequency
match that indicated on the unit's specification plate.
It is essential that the electrical installation to which the bottle cooler is going to be connected has an EARTH, as
well as the appropriate circuit breaker and residual current protection (we advise 30 mA)
Check that the cross-section of the power supply outlet is appropriate for the consumption that it is going to
withstand.
The socket must be the Schuko type as the cable from your cabinet is this type (also called type F or CEE 7/4"),
with 4.8 mm terminals and earth.
This input power cable must not be extended for your safety.
Do not insert an element of any kind through the fan projection grilles or cooling equipment area.
On start-up, ensure that there is no heat source nearby.
For the cooling system elements to operate correctly, it is very important that the air inlet and outlet are not
covered.
Do not install the bottle cooler outdoors.
www.combisteel.com
4
Werbung
