Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The system has emergency ways to deactivate security and anti-hijack functions (using the VALET
button and the "Secret PIN-code") in case of loss or failure of control devices or in case of discharge of a
battery (when you cannot replace it or charge).
Before using emergency system control, check the system and vehicle control devices: check a
battery, turn on a device in accordance with its manual (if required).
If all devices are working, try to make a primary vehicle diagnosis: check the vehicle original control
device, vehicle battery charge level, gearbox selector position, check information on the dashboard.
!
T
he sysTem can be conTrolled from a phone using
0* –
.
disarming
998*
– d
xxxх
eacTivaTe auThorizaTion devices
"
code
wriTTen on The
1*– a
.
rming
888* – a
cTivaTe auThorizaTion devices
!
r
ead The procedure for enTering The
ENTERING THE PIN-CODE
The code must be entered only when the base unit is powered and the ignition is off. The PIN-code can
be entered using the external or located on the base unit VALET button. The digits input and correct
input is indicated by the external or located on the base unit LED indicator.
• Enter the first digit • Press the button the number of times equal to the first digit. Pauses between
presses should not exceed 1 second. Each pressing will be confirmed with an orange LED indicator flash.
Pause for more than 1 second, a red LED indicator flash and a short sound single of the Beeper confirm
the input of the first digit. Then you can enter the next digit.
• Enter the second digit • Press the button the number of times equal to the second digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange LED
indicator flash. Pause for more than 1 second, a red LED indicator flash and a short sound single of the
Beeper confirm the input of the second digit. Then you can enter the next digit.
• Enter the third digit • Press the button the number of times equal to the third digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange LED
indicator flash. Pause for more than 1 second, a red LED indicator flash and a short sound single of the
Beeper confirm the input of the third digit. Then you can enter the next digit.
• Enter the fourth digit • Press the button the number of times equal to the fourth digit. Pauses
between presses should not exceed 1 second. Each pressing will be confirmed with an orange LED
indicator flash. The correct input will be confirmed with the series of green and red flashes of the LED
indicator.
50
o
'
wner
s personal card under The proTecTive layer
(i
mmobilizer and
pin-
code before using emergency funcTions
dTmf
commands
(i
a
-h
mmobilizer and
nTi
a
-h
nTi
ijack funcTions
SECURITY-SERVICE SYSTEM PANDORA CAMPER PRO
:
),
ijack funcTions
where хххх is The
.
).
.
"s
pin-
ecreT
Werbung
