Service mode
It is recommended to put the system into the service mode before handing it to a car service or valet
parking. When this mode is switched on, security system stops interfering with built-in electronics and
disables all functions to ease maintenance.
To switch on this mode, disarm the system, turn on the ignition, an authorization device (a radio
tag, a remote control, a mobile phone) must be in the coverage zone, enter the "Immobilizer PIN-
code" (if the "Code immobilizer" function is used) and use one of the method described below:
Radio tag
To activate/deactivate service mode, press and hold the
(until the third flash of the LED), release the button.
Phone
Call the system number wait for the answer.
• To activate service mode, dial the
from the Owner's personal card.
• To deactivate service mode dial the
•
Mobile application
To activate/deactivate service mode, open the mobile application. When the system is online (there
is an Internet or Bluetooth connection), press and hold the
the scale is fully loaded.
!
T
o change buTTons layouT or add new buTTons on The conTrol panel
Immobilizer buttons
• To activate service mode, enter the "Immobilizer PIN-code" and press the immobilizer button 10
times within 20 seconds.
• To deactivate service mode, turn on the ignition and enter the "Immobilizer PIN-code".
Service mode indication
• Activated Service mode is indicated by: an icon
when the ignition is on, long sound signal of a Beeper at the moment you activate the mode.
• Deactivated Service mode is indicated by: no "Service mode" icon
the mobile application, no constant green LED when the ignition is on, two long sound signal of a
Beeper at the moment you deactivate the mode.
48
5
5
1
*
DTMF command and then dial the "Secret PIN-code"
5
5
2
*
DTMF command.
in the mobile application, constant green LED
SECURITY-SERVICE SYSTEM PANDORA CAMPER PRO
button on a radio tag for 3 seconds
button on the control panel until
,
"s
c
go To
eTTings
onTrol buTTons
in the mobile application in
".