Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ANTI-HI-JACK-2 mode – The base unit constantly checks if an authorization device is in the radio
coverage zone when ignition is on.
If the system cannot detect an authorization device, the base unit will perform a delayed engine
blocking. The siren will play the 'Engine blocking warning' ringtone before blocking. The engine will
be blocked immediately or at the time the car starts moving, it depends on system settings. When an
authorization device appears in the coverage zone, the system will exit blocking mode and will continue
to work in normal mode.
!
T
his mode is disabled by defaulT
Multi-button code immobilizer (pin-to-drive)
Multi-button code immobilizer (pin-to-drive) is a function that allows disarming, disabling blocking and
controlling service mode and time channels using original vehicle controls (button, lever or pedal) and
a pre-programmed PIN-code (the "Immobilizer PIN-code").
AN EXAMPLE OF USING THE FUNCTION
• Turn on the ignition to disable engine blocking or enable service mode, turning on the ignition is not
required if you want to disarm the system or control time channels.
• Enter the "Immobilizer PIN-code". Press a programmed button/lever/pedal the number of times equals
to the first digit. Pauses between presses should not exceed 1 second. More than 1 second pause will be
interpreted as the start of the next digit input. The immobilizer code can consist max of 4 digits from 1 to 9.
• The system will confirm the correct input by a sound signal of the beeper and a programmed
function will be performed.
!
T
his mode is disabled by defaulT
Checking the number of paired remote controls/radio tags/mobile device
The number of paired remote controls/radio tags/mobile device can be checked by the number of
flashes of the LED indicator. The number of paired remote controls/tags/mobile device can be checked
when switching on the ignition (the system must be disarmed). The number of orange flashes will
indicate the number of paired remote controls, the number of green flashes will indicate the number of
paired radio tags, a following red flash will indicate a paired mobile device.
You can also check the number of paired remote controls/radio tags/mobile device by taking off
and putting back on battery terminal. The system will emit short sound signals from a siren
• First series of the siren signals
• The second series of the siren signals
paired radio tags
• The third long signal
USER MANUAL
. i
T is required To make addiTional seTTings and connecTions for This mode
. i
T is required To make addiTional seTTings and connecTions for This mode
indicates the number of paired remotes
after a pause of 2 seconds indicates the number of
after a pause of 2 seconds indicates a paired mobile devices.
EN
.
.
.
17
Werbung
