Nikon EDG 85-A VR Bedienungsanleitung Seite 16

Inserting batteries
En 1. Remove the battery holder from the body
Release the battery holder lock (Fig.1), then remove it from the Fieldscope
Es
body (Fig.2) .
Fr
2. Insert the batteries
De
Insert the batteries in the direction indicated inside the battery holder (Fig. 3).
3. Attach to the Fieldscope body
It
Position the battery holder as in (Fig.4), then push the nearside of the holder
Se
down to lock (Fig.1).
Nl
Precautions when changing batteries
Ru
・ Before replacing batteries, make sure the VR lock knob is in the locked position,
Pt
then remove the battery holder. If the knob is not locked, accidental contact
Pl
with the VR ON/OFF button may turn VR on. This might cause the product to
malfunction.
Fi
・ When replacing batteries outdoors, be sure that no liquid enters the battery holder.
・ Avoid metal contact with the battery holder connection. Such contact may cause
No
problems.
Dk
Cz
Locking the battery holder
・ Fix the battery holder in the correct position, and make sure it is locked properly
Ro
(Fig. 1). If it is not locked, it might fall unexpectedly.
Hu
Keep the battery holder connection clean
・ Do not open the battery holder in humid conditions such as in the rain or near the
sea, or in a dusty area. This might cause a contact failure.
・ When changing the batteries, be sure not to dirty the connection as this might
cause poor contact.
Use fully charged batteries at low temperatures and prepare spare
batteries.
・ When using weak batteries at low temperatures, VR function may not operate.
In cold conditions, use new batteries or fully charged batteries. Also, keep spare
batteries warm, for use in alternate shifts. Even if batteries do not work at low
temperatures, they may function again at a normal temperature.
16
(Fig. 1)
Lock Release
(Fig. 2)
(Fig. 3)
(Fig. 4)