Herunterladen Diese Seite drucken

Hautau SKA 20 Montageanleitung Seite 29

Werbung

Technische Daten (Forts.)
Einbau­ und Umgebungsbedingungen
Nenntemperatur
Umgebungstemperatur
Schutzart
Umweltbedingungen
geeignet für
natürliche Lüftung
geeignet für die Verwen dung
in Rauchableitungen nach
LBO / MBO
Werkseinstellung
Einzelantrieb
Adresse
Geräte Typ Byte
Konfiguration ohne Software
Setbildung
Selbsterkennung und
Neueinlernen
Reset
* Hinweis: der Antrieb / die Antriebe benötigen
eine 24 V-Hilfsspannung
Hinweise zur Energieversorgung und Ansteuerung
Schaltnetzteile (SNT) und
Trafonetzteile
Schaltaktoren
Zulassungen und Nachweise
Elektrische Sicherheit
EMV Verträglichkeit
CE konform
TÜV Baumuster-Zulassung
EG Einbauerklärung
20°C
-5°C bis +75°C (Umweltklasse 1
gemäß VdS 2580)
IP 20 nach DIN EN 60529
nur für trockene Umgebungen;
keine Taubildung, keine aggres-
siven Dämpfe, keine staubigen
Umgebungen
ja
ja
konfiguriert als Einzelantrieb, zur
direkten Verwendung an einem
Fenster
22, veränderbar per ConfigTool
101, nicht veränderbar
ja*, max. 2 Antriebe +
1 Verriegelung
ja*
ja*, Rücksetzung als Einzelantrieb*
C-Last geeignet mit Energie-
reserven für den Einschalt- und
Abschaltmoment der Antriebe
C-Last geeignet, Pausenzeiten
bei Polwendung sind zu beachten
ja, gemäß EN 60335-1
ja, nach DIN EN 55014-1,
55014-2 und 61000-6-3
ja, gemäß EMV Richtlinie
2004/108/EG und Niederspan-
nungsrichtlinie 2006/95/EG
ja
ja, siehe www.HAUTAU.de
hergestellt und geprüft gemäß
europäischen Richtlinien
Technical specifications (cont'd)
Installation and environmental conditions
Nominal temperature
Ambient temperature range -5 °C to +75 °C (environmental
Protection system
Environmental conditions
Suitable for
natural ventilation
Suitable for the use within
smoke removals acc.
to LBO / MBO
Factory setting
Single drive
Address
Geräte Typ Byte
Configuration without software
Set formation
Auto-detection and
new teaching-in
Reset
* Note: the drive(s) require a 24 V auxiliary power supply
Notes for power supply and control
Switching power
supplies (SNT) and trans -
former power supplies
Switch actuators
Approvals and certificates
Electrical safety
EMC compatibility
CE compliant
TÜV type approval
EC Declaration of
incorporation
20°C
category 1 acc. to VdS 2580)
IP 20 acc. to DIN EN 60529
for dry environments, only;
no dew formation, no aggressive
fumes, no dusty environments
yes
yes
configured as single drive, for
direct application at one window
22, modifiable with ConfigTool
101, not modifiable
yes*, max. 2 drives + 1 locking
yes*
yes*, resetting as single drive*
suitable for C-load with power
reserves for the moment of
switching-on and switching-off
of the drives
suitable for C-load, consider pause
times in case of pole reversal
yes, acc. to EN 60335-1
yes, acc. to DIN EN 55014-1,
55014-2 und 61000-6-3
yes, acc. to EMC Directive
2004/108/EG and Low-voltage
Directive 2006/95/EG
yes
yes, refer to www.HAUTAU.de
manufactured and tested acc. to
European directives
29

Werbung

loading