Operation; Resetting To The Initial State - HomeMatic HM-LC-Dim1T-Pl-3 Bedienungsanleitung

ton „Inbox (x new devices)" indicates how many new
devices have been taught-in successfully.
• If required, you can teach-in additional devices by re-
peating the steps described above for each device.
• Now configure the newly taught-in devices in the in-
box as described in the next section.
Configuring newly taught-in devices
Once you have taught-in your dimming acutator to the
HomeMatic Central Control Unit, it will be moved to
the inbox. Here, you must configure the device and its
associated channels in order to make them available
for operating and configuration tasks. Give the device
a name and assign it to a room. You can also make
individual parameter settings.
Now you can use the „WebUI" user interface to control
your device, configure it, link it directly to other de-
vices, or use it in central control unit programs. Please
refer to the HomeMatic WebUI manual for more details
(available for download in the „Downloads" area of the
website www.homematic.com).
40
7

Operation

After teach-in has been performed, simple operator
functions are available via the taught-in control elem-
ents. Press and release the button: ON/OFF, press and
hold down the button: dim. Press the button as follows
to trigger the corresponding response:
Button
Press and release "ON" button
Press and release "OFF" button
Press and hold down "ON" button
Press and hold down "OFF" button Dim down
8

Resetting to the initial state

To reset the actuator to the initial state, put the device
into teach-in mode using the channel button (hold it
down for at least 4 seconds). If the device is in teach-
in mode, hold the channel button down for at least 4
seconds again. If the device LED flashes quickly, this
indicates that the actuator is being reset.
Response
ON
OFF
Dim up
41