LEITZ complete Bedienungsanleitung Seite 8

Audio reproduction over wire connection
You can also use the speaker if your audio source does not have Bluetooth or there
is no Bluetooth connection. Use an audio cable with 3.5-mm mini jacks for this pur-
pose (not supplied).
1. Connect one end of the cable to the headphones or line output of your audio
source.
2. Connect the other end of the cable to the additional audio input (AUX IN) on the
rear of the speaker.
3. Operate your audio source as usual to control playback and volume.
Note:
•
If both a Bluetooth and cable connection exist, the Bluetooth connection has pri-
ority.
•
The speaker cannot control the audio source via the cable connection. It only
reproduces the audio signal received via the cable.
8
EN