SuperFish ALU Tech UVC Gebrauchsanweisung Seite 4

GB - SuperFish ALU Tech UVC 40 Watt
The ALU Tech UVC is a professional UVC clarifier for large ponds. It ensures a clear
pond with healthy fish. The UV lamp produces ultraviolet light with a wavelength of
exactly 254 nm. The UV-C radiation kills almost all harmful bacteria, viruses and
fungi and keeps algae growth under control.
Safety
• Read this manual carefully before usage.
• Suitable for outdoor usage.
• This UVC should be only used for cleaning pond water and the water temperature should not
exceed 35°C. It should never be used for other liquids or chemicals.
• This UVC device produces harmful radiation, direct contact may be dangerous for eyes and skin.
• Never look at a burning UV lamp, switch of the power before any maintenance and when
opening the UVC clarifier
• The device may only be connected to an electrical installation that meets the legal requirements.
A GFCI (30 mA) and earthed sockets are required. If in doubt always use a certified electrician to
install.
• Ensure voltage shown on the label match to the mains supply voltage.
• The UVC plug may only be connected to an earthed wall socket. Ensure that water cannot reach
the socket (fig. A).
• The UVC device, the electronic ballast and the plug must be installed in a dry place, spatter-free
and at least 2 meters away from the pond.
• Take great care using electricity in combination with water, do not operate with wet hands or plug
is wet. Never operate the clarifier if there are people in the water.
• In the event of damage to the unit, quarts glass, cord or plug, do not use the unit and return the
unit to your dealer for repair or recycling.
• Unplug or switch off all appliances in the pond before carrying out maintenance. Be aware that
the lamp can remain hot for up to 10 minutes after being disconnected.
• The UVC device may only be connected if there is a sufficient flow of water.
• The UVC device can withstand a maximum pressure of 3 bar.
• This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instructions concerning the use of the appliance in a safe way and
understand the hazards involved. Children may not play with the appliance. Cleaning and user
maintenance shall not be done by children without supervision.
Grounding the UVC device
• The grounding pin is located on the plastic part of the UVC on the inlet side.
• Ground the UVC device in the order shown below and in figure B.
• Slide the eye of the earthing cable (A) over the grounding pin (B) that is attached onto the
housing (C).
• Slide the first toothed washer (D) over the grounding pin.
• Tighten the hexagon nut (E) onto the grounding pin.
• Slide the second toothed washer (D) over the grounding pin.
• Clip the strain relief clip (F) around the grounding cable approx. 10 cm from the metal eye (A).
• Slide the eye of the strain relief clip (F) over the grounding pin so that the grounding cable makes
a loop.
• Tighten the locknut (G) on the grounding pin (tighten carefully).
4
/ 75 Watt
40,000 L 75,000 L