clage Zip HydroTap G4 BCS 160/175 Gebrauchsanleitung Seite 41

If the carbon dioxide gas bottle is empty, replace it as follows:
1. Close the red lever on the pressure reducer.
2. Turn the pressure adjusting screw on the pressure reducer anti-
clockwise as far as it will go (no pressure).
3. Replacing the carbon dioxide gas bottles:
Gas bottle with self closing valve:
> Unscrew the gas bottle from the pressure reducer.
> Quickly screw the new, full gas bottle into the pressure reducer,
as far as it will go.
> Secure the new gas bottle in place on the holder so that it cannot
topple over.
Gas bottle with hand wheel:
> Close the shut-off valve on the gas bottle.
> Undo the union nut connecting the gas bottle to the pressure
reducer.
> Remove the gas bottle and secure the new gas bottle in place on
the holder so that it cannot topple over.
> Connect the pressure reducer to the new, full gas bottle. Tighten
the union nut moderately tight.
4. Set a delivery pressure of 3.0 bar on the pressure reducer of the
carbon dioxide gas bottle. Turn the adjusting screw anticlockwise
to reduce the pressure. Turn it clockwise to increase the pressure.
5. Open the red lever on the pressure reducer.
6. Check the gas-carrying connections for leaks. Caution - gas re-
leased can be very cold. Use a leak detecting spray or soapy water
so that even minor leaks will be detected.
Note: The room where a carbon dioxide gas bottle is placed must
have a minimum room volume of 17 m
capacity. This means in a room with an assumed room height of
2.2 m, you will need an area of 7,7 m
Note: The carbon dioxide gas bottle must always be used in the up-
right position to ensure that the pressure reducer operates correctly
and thus ensure the safety of the unit!
Note: The carbon dioxide gas bottle must not be exposed to temper-
atures higher than 35 °C! Cooling should be provided if necessary.
CO Bottle Replacement
2
for every kg of bottle
3
2
41