Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
·
The table drill is to a large extent mainte-
nance-free. Keep the device clean. Pull out
the mains plug before doing any cleaning and
maintenance work on the machine. Do not
use any harsh, abrasive cleaning solvents.
Ensure that no liquid seeps into the device.
Regrease all bare parts when the work is
finished. The drill pillar, blank parts of the
column, and the drill table especially should
be regreased at regular intervals. Use a stan-
dard, acid-free lubricating grease to do this.
Caution: Do not use your household refuse
bin as a receptacle for oil and grease-soaked
cleaning rags or grease and oil sludge. Dis-
pose of these toxic materials in an environ-
mentally-friendly fashion. Regularly check and
clean the ventilation holes. Store the device
in a dry room. Should the device become
damaged, do not try to repair it yourself; leave
this work to the hands of a qualified electrical
technician.
·
W
e
r
c e
o
m
m
e
n
d
h t
a
y t
o
immediately each time you have finished
using it.
·
C
e l
a
n
h t
e
e
q
u
p i
m
e
t n
e r
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device. The ingress of
water into an electric tool increases the risk of
an electric shock.
GB
8.2 Maintenance
·
·
·
·
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should be
taken to a suitable collection center for proper dis-
posal. If you do not know the whereabouts of such
a collection point, you should ask in your local
council o ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
Before transporting the bench drill, dismantle it
into its individual parts and pack them ideally in
u
c
e l
a
n
h t
e
d
e
v
c i
e
g
l u
r a
y l
i w
h t
a
m
i o
t s
the tool's original packaging for the best possible
protection against impact and shock.
- 15 -
Check at regular intervals that the safety-rele-
vant components of the drill are working.
If you replace any safety-relevant compo-
nents, e.g. the microswitch of the chip guard,
they must be checked for proper operation
before the drill is switched on again.
To prevent any assembly errors during main-
tenance, note the instructions in the chapter
on "Assembly".
There are no other parts inside the tool which
require maintenance.
Werbung
