Werbung
Verfügbare Sprachen
Verfügbare Sprachen
h) Never remove drilling chips from the dril-
ling area while the power tool is running.
To remove chips, move the drilling tool
away from the workpiece, switch o
power tool and wait until the drilling tool
has come to a standstill. Use aids such
as a brush or a hook to remove the chips.
Contact with rotating parts or drilling chips
could cause injuries.
i)
The maximum permissible speed of plug-
in tools with rated speeds must be at
least as high as the maximum speed spe-
ci ed on the power tool. Accessories which
rotate faster than the permissible speed may
break and be catapulted out of the tool.
Special safety information
The bench drill was designed in such a way so
as to all but eliminate potential hazards when the
machine is properly used. However, there are a
few safety precautions to observe in order to en-
sure that all residual hazards are ruled out.
Ensuring proper voltage
The voltage must comply with the speci cations
on the rating plate.
Using a socket-outlet with earthing contact
The device is allowed to be operated only from an
outlet with a properly installed earthing contact.
Important! Extension cable
The cord cross section of an extension cable
must measure at least 1.5 mm . Always comple-
tely unwind a cable reel prior to use. Check the
cable for defects.
Protection against electrical shock
Keep the device away from moisture. The device
must neither be damp, nor be operated in a humid
environment. Prior to every use, check the device
and the mains cable with plug for damage. Avoid
bodily contact with earthed parts e.g. pipes, hot
elements etc.
Protection against
re and explosion
There are spark producing components inside
the device. Do not use the device in the vicinity of
combustible liquids or gases. Not doing so intro-
duces the risk of re or explosion.
Handling the device with care
Do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges. Keep mounted attachments sharp and
GB
clean to enable you to work well and safely. Fol-
low the maintenance regulations and the instruc-
tions for changing mounted attachments such as
the
cutting-o wheels, blades and bits.
Wearing suitable work clothes and personal
protection equipment (PPE)
Loose clothing is not suitable, as it can be caught
by moving parts, or you can become entangled.
Wear a hair net if you have long hair. As a general
rule, jewelry should not be worn when working
with machine tools. Ensure that you wear safety
goggles. Not doing so could result in eye injury.
Keeping the work area neat and tidy
Disorder in the work area can easily lead to acci-
dents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses
a tripping hazard! Ensure that there is su cient
lighting.
Watching out for other persons
Watch out for other persons when using the de-
vice (especially children), and keep them away
from your work area. Do not let anyone touch the
device or the power cable.
Storing the tools in a safe location
Store unused devices in a dry, locked location
that is out of the reach of children.
Avoiding overload of device
Operate the device only within the speci ed out-
put range. Do not use any low-powered machines
for heavy duty work. Do not use electric tools to
perform work for which they were not intended.
Maintaining a steady foothold
Ensure that you maintain a steady foothold while
working. Avoid abnormal body positions and al-
ways keep your balance.
Pulling out the power plug
Pull out the power plug when not using the tool,
prior to maintenance, and when changing the drill
bit.
Pulling out the power plug
Ensure that the mains connection is protected by
at least a 10 A fuse.
Avoiding unintentional start-up
Make sure that the switch is OFF when inserting
the plug in the socket-outlet.
- 9 -
Werbung
