Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Keeping an eye on your work
Always keep an eye on your machine and the
object you are working on. Never use the machine
when you are not concentrating or are distracted.
Never use the machine when you are under the
in uence of alcohol or are taking medication.
Maximum workpiece size
Workpieces (max. 20 x 20 cm) are allowed to be
processed only if they can be clamped securely
on the drill table or in the vise.
Checking the tool for damage
Before the tool is used, safety devices and any
slightly damaged parts must be carefully checked
to ensure that they are in good working order. Vi-
sually examine the tool's power cable on a regular
basis. All parts must be correctly assembled and
meet all the conditions required to ensure proper
operation. Any damaged safety devices and parts
must be properly repaired or replaced by a pro-
fessional repair shop unless otherwise speci ed
in the operating manual. Never use tools with
defective On/O switches.
Jammed drill bits
Switch o the power tool immediately if the drill bit
becomes jammed in the workpiece. The drill bit
can become jammed e.g. if you apply too much
pressure while drilling or if the bit becomes tilted
in the workpiece.
Applying grease
Apply commercially available grease to the drill
pillar from time to time.
Lubricants
To prevent the drill bit from overheating, use a
lubricant that is commercially available for this
bench drill.
Warning! Using plug-in tools and accessories
other than those speci ed in these operating inst-
ructions can lead to a risk of injury.
GB
Special information about the laser
Caution! Laser radiation
Do not look into the beam
Laser class 2
CAUTION ! - LASER RADIATION !
Do not look into the beam!
Laser specification
Laser class 2
: 650 nm; P
·
Never look directly into the laser path.
·
Never direct the laser beam at reflecting sur-
faces or persons or animals. Even a low out-
put laser beam can inflict injury on the eye.
·
Caution: It is vital to follow the work proce-
dures described in these instructions. Using
the equipment in any other way may result in
hazardous exposure to laser radiation.
·
Never open the laser module.
·
It is prohibited to carry out any modifications
to the laser to increase its power.
·
The manufacturer cannot accept any liability
for damage due to non-observance of the
safety information.
Now, please read and follow all steps and
procedures included in the operating instruc-
tions.
2. Layout and items supplied
2.1 Layout (Fig. 1-4)
1. Base plate
2. Drill pillar
3. Chuck
4. Gear selector switch
5. On/O switch
6. Display
7. Motor unit
8. Hand wheel
9. Fastening screw
10. Clamping screw
11. Crank arm
12. Speed button
13. Zero point button
and
Laser button
14.
LED button
Switch button
15.
16. Fastening screw
- 10 -
0
Werbung
