NMC WALLSTYL Montageanleitung Seite 31

SAFETY InSTRUCTIOnS
The safety instructions below apply to the nmC ARSTYL® light frames and wALLSTYL® baseboard lights and their accessories. Please
read these safety instructions before completing your nmC lighting installation. If you have any questions, please contact nmC. Please
retain these safety instructions carefully; if necessary, you can download them from our website www.nmcdecoration.com in PDF.
nmC lighting is designed solely for indoor use. never install nmC lighting outdoors.
ASSEmBLY AnD USE
• Before using your nmC lighting, do check that all safety and/or positioning screws are sitting firmly, and tighten them if necessary.
• wALLSTYL® baseboard lights must be fitted and connected to the electricity supply by a qualified electrician. Before connection, it is
essential to switch off the circuit's power supply, remove the fuse, or switch off the circuit breakers as appropriate.
• Do not store or keep any flammable material close to nmC lights.
• never touch nmC lights with wet hands and/or feet.
• Do not operate nmC lights in very dusty, damp and/or wet environments
• You should under no circumstances block up the fans on the corresponding nmC lights.
• never cover the openings in the casings on the nmC light(s), and never insert any item into the openings in the casings on the nmC
light(s) – the main dangers include electric shock, device malfunction, short circuit and/or burns.
• Do not carry your nmC light(s) by the cable and/or accessory.
• Be sure to lay the cable so that it does not represent a trip hazard, and ideally not on the floor.
• Be sure to check that the cable is not crushed, driven over, stretched or bent.
• Be sure to check that cables are not frayed and/or otherwise damaged.
• Be aware of possible risks of thermal, mechanical and/or chemical damage to cables and be sure to avoid these at all costs.
• never operate nmC lights with defective cables and/or plugs. Defective cables must be changed only by nmC or an authorised
specialist dealer. Under no circumstances must cables on nmC lights be 'patched up'.
• when using nmC lights, it is essential to ensure that the electricity supply is set up to run nmC continuous lights.
• During assembly, ensure secure fixing to the wall / ceiling. when fitting to ceilings, it is mandatory for an extra steel cable attachment
to be applied. To fit the Plexiglas, simply insert it into the insertion sockets provided.
• You must respect the necessary connection of the protective earth (green/yellow) of the mains lead to the protective earth terminal.
ATTEnTIOn
Defective lights must only be repaired by an expert, because unqualified repairs can cause serious consequential damage. no bare
wires must protrude from the terminal.
DImmInG
The lights are not factory-set to be dimmable. This means you will need a standard dimmer/converter, which is not included. The dimmer
should have the following properties:
- class III, independent dimmer for 12V or 24V to dim an LED channel
- single-channel Pwm output dimmer with potentiometer (adjustable resistance / (150kΩ) or 1-10V signal)
It should be connected by a qualified expert.
CARE AnD mAInTEnAnCE
Care is limited to the surfaces, or Plexiglas areas and covers.
when cleaning, ensure that no moisture can reach the terminal areas or live parts.
DISPOSAL
Electrical equipment , accessories and packaging should be recycled in an environmentally appropriate manner. never throw electrical
equipment in your household rubbish.
For EU countries only: European Directive 2012/19/EU on waste Electrical and Electronic Equipment (wEEE) and its transposition into
national law requires that waste electrical equipment be collected separately and sent for environmentally appropriate recycling.
Subject to modifications
31